CICECO-Aveiro Institute of Materials

Funder

Organizational Unit

Publications

Cu(In,Ga)Se$$_2$$-based solar cells for space applications: Proton irradiation and annealing recovery

Publication . Candeias, Maria B.; Fernandes, Tiago V.; Falcão, Bruno P.; Cunha, António F.; Cunha, José M. V.; Barbosa, João; Teixeira, Jennifer P.; Fernandes, Paulo A.; Peres, Marco; Lorenz, Katharina; Salomé, Pedro M. P.; Leitão, Joaquim P.

In this work, we present an experimental study of a Cu(In,Ga)Se2 (CIGS)-based solar cell (SC), irradiated with protons of energy 80 and 180 keV and with fuences of 1012 , 1013 , and 1014 cm−2 , as well as a strategy to recover the induced damage. The possible modifcations of the structural, electrical, and optical properties, induced by the proton irradiation, were investigated. Although the irradiation did not promote any major modifcation in the crystalline structure, it did induce the creation of defects responsible for changes in the electronic structure which caused a partial PL quenching and signifcant changes in the PL spectral shape, as well as a reduction of the power conversion efciency and open-circuit voltage of up to 30% as revealed by J–V measurements. The photoluminescence results showed a broadening, redshift and decrease in the signal-to-noise ratio. The recovery of damage induced by irradiation in several SCs was tested through annealing steps performed at diferent temperatures and time intervals. It was found that the best recovery strategy for the investigated irradiation parameters was carrying out several isothermal annealing at 200°C for 30 min. This strategy is compatible with the intermitent variation of the temperature in space and allowed to recover a power conversion efciency comparable to that of the as grown cell. In particular, it must be highlighted that keeping the SC at room temperature in ambient atmosphere and in the dark, did not promote signifcant recovery in contradiction with some previous reports. This recovery methodology was applied in parallel for non-irradiated SCs and no increase in power conver sion efciency was found, but rather a slight decrease. The dominant radiative recombination channel was, apparently, unchanged with the irradiation and the subsequent recovery process. Nonetheless, changes in the concentration of defects of diferent types cannot be excluded, which is in line with a signifcant infuence of fuctuating potentials in both as grown and after recovery stages of the solar cell. This work constitutes a frst systematic study that simultaneously encompasses the infuence of proton irradiation on the optical and electrical properties of CIGS SCs and a damage recovery methodology with a high potential to be explored in space applications. Additionally, it contributes to reinforcing the high potential of CIGS technology in the context of creating constellations of small satellites that are being developed by diferent entities, particularly private ones.

2023Journal article

Restricted access

Coupling of plasmonic nanoparticles on a semiconductor substrate via a modified discrete dipole approximation method

Publication . Carvalho, Diogo F.; Martins, Manuel A.; Fernandes, P. A.; Correia, M. Rosário P.

Understanding the plasmonic coupling between a set of metallic nanoparticles (NPs) in a 2D array, and how a substrate affects such coupling, is fundamental for the development of optimized optoelectronic structures. Here, a simple semi-analytical procedure based on discrete dipole approximation (DDA) is reported to simulate the far-field and near-field properties of arrays of NPs, considering the coupling between particles, and the effect of the presence of a semiconductor substrate based on the image dipole approach. The method is validated for Ag NP dimers and single Ag NPs on a gallium nitride (GaN) substrate, a semiconductor widely used in optical devices, by comparison with the results obtained by the finite element method (FEM), indicating a good agreement in the weak coupling regime. Next, the method is applied to square and random arrays of Ag NPs on a GaN substrate. The increase in the surface density of NPs on a GaN substrate mainly results in a redshift of the dipolar resonance frequency and an increase in the near-field enhancement. This model, based on a single dipole approach, grants very low computational times, representing an advantage to predict the optical properties of large NP arrays on a semiconductor substrate for different applications.

2022Journal article

Restricted access

Bonding to Psychedelics: Synthesis of Molecularly Imprinted Polymers Targeting 4-Bromo-2,5-dimethoxyphenethylamine (2C-B)

Publication . Martins, Daniel; Fernandes, Carlos; Mendes, Ricardo F.; Cagide, Fernando; Silva, António Fernando; Borges, Fernanda; Garrido, Jorge; Garrido, Jorge

The increasing interest in utilizing psychedelics for therapeutic purposes demands the development of tools capable of efficiently monitoring and accurately identifying these substances, thereby supporting medical interventions. 4-Bromo-2,5-dimethoxyphenethylamine (2C-B) has gained significant popularity as one of the most widely used psychedelic compounds in non-medical settings. In this study, we aimed to create a material with selective recognition of 2C-B by synthesizing a series of molecularly imprinted polymers (MIP) using 2C-B as the template and varying ratios of methacrylic acid (MAA) as the functional monomer (1:2, 1:3, and 1:4). Both thermal and microwave-assisted polymerization processes were employed. The molar ratio between the template molecule (2C-B) and functional monomer (MAA) was 1:4, utilizing a microwave-assisted polymerization process. Isotherm studies revealed a Langmuir’s maximum absorption capacity (Bmax) value of 115.6 μmol·mg−1 and Kd values of 26.7 μM for this material. An imprint factor of 4.2 was determined for this material, against the corresponding non-imprinted polymer. The good selectivity against 14 other new psychoactive substances highlighted the material’s potential for applications requiring selective recognition. These findings can contribute to the development of tailored materials for the detection and analysis of 2C-B, supporting advancements in non-medical use monitoring and potential therapeutic models involving psychedelics.

2024Journal article

Open access