Publication
Wind resource modelling in complex terrain using different mesoscale–microscale coupling techniques
| dc.contributor.author | Carvalho, David | |
| dc.contributor.author | Rocha, Alfredo | |
| dc.contributor.author | Santos, Carlos Silva | |
| dc.contributor.author | Pereira, R. | |
| dc.date.accessioned | 2014-02-25T16:56:00Z | |
| dc.date.available | 2014-02-25T16:56:00Z | |
| dc.date.issued | 2012 | |
| dc.description.abstract | Wind resource evaluation in two sites located in Portugal was performed using the mesoscale modelling system Weather Research and Forecasting (WRF) and the wind resource analysis tool commonly used within the wind power industry, the Wind Atlas Analysis and Application Program (WAsP) microscale model. Wind measurement campaigns were conducted in the selected sites, allowing for a comparison between in situ measurements and simulated wind, in terms of flow characteristics and energy yields estimates. Three different methodologies were tested, aiming to provide an overview of the benefits and limitations of these methodologies for wind resource estimation. In the first methodology the mesoscale model acts like “virtual” wind measuring stations, where wind data was computed by WRF for both sites and inserted directly as input in WAsP. In the second approach, the same procedure was followed but here the terrain influences induced by the mesoscale model low resolution terrain data were removed from the simulated wind data. In the third methodology, the simulated wind data is extracted at the top of the planetary boundary layer height for both sites, aiming to assess if the use of geostrophic winds (which, by definition, are not influenced by the local terrain) can bring any improvement in the models performance. The obtained results for the abovementioned methodologies were compared with those resulting from in situ measurements, in terms of mean wind speed, Weibull probability density function parameters and production estimates, considering the installation of one wind turbine in each site. Results showed that the second tested approach is the one that produces values closest to the measured ones, and fairly acceptable deviations were found using this coupling technique in terms of estimated annual production. However, mesoscale output should not be used directly in wind farm sitting projects, mainly due to the mesoscale model terrain data poor resolution. Instead, the use of mesoscale output in microscale models should be seen as a valid alternative to in situ data mainly for preliminary wind resource assessments, although the application of mesoscale and microscale coupling in areas with complex topography should be done with extreme caution. | por |
| dc.identifier.doi | 10.1016/j.apenergy.2013.03.074 | pt_PT |
| dc.identifier.issn | 0306-2619 | |
| dc.identifier.uri | http://hdl.handle.net/10400.22/4065 | |
| dc.language.iso | eng | por |
| dc.peerreviewed | yes | por |
| dc.publisher | Elsevier | por |
| dc.relation.ispartofseries | Applied Energy; Vol. 108 | |
| dc.relation.publisherversion | http://www.sciencedirect.com/science/article/pii/S0306261913002705 | por |
| dc.subject | Wind energy | por |
| dc.subject | Wind simulation | por |
| dc.subject | Mesoscale models | por |
| dc.subject | Microscale models | por |
| dc.subject | WRF | por |
| dc.subject | WAsP | por |
| dc.title | Wind resource modelling in complex terrain using different mesoscale–microscale coupling techniques | por |
| dc.type | journal article | |
| dspace.entity.type | Publication | |
| oaire.citation.endPage | 504 | por |
| oaire.citation.startPage | 493 | por |
| oaire.citation.title | Applied Energy | por |
| oaire.citation.volume | 108 | por |
| rcaap.rights | openAccess | por |
| rcaap.type | article | por |