Browsing by Author "Vieira, A. Aguiar"
Now showing 1 - 3 of 3
Results Per Page
Sort Options
- Drilling delamination outcomes on glass and sisal reinforced plasticsPublication . Durão, Luís M.; Gonçalves, Daniel J. S.; Tavares, João Manuel R. S.; Albuquerque, Victor Hugo C. de; Panzera, Túlio Hallak; Silva, Leandro J.; Vieira, A. Aguiar; Baptista, A. P. M.Nowadays, fibre reinforced plastics are used in a wide variety of applications. Apart from the most known reinforcement fibres, like glass or carbon, natural fibres can be seen as an economical alternative. However, some mistrust is yet limiting the use of such materials, being one of the main reasons the inconsistency normally found in their mechanical properties. It should be noticed that these materials are more used for their low density than for their high stiffness. In this work, two different types of reinforced plates were compared: glass reinforced epoxy plate and sisal reinforced epoxy plate. For material characterization purposes, tensile and flexural tests were carried out. Main properties of both materials, like elastic modulus, tensile strength or flexural modulus, are presented and compared with reference values. Afterwards, plates were drilled under two different feed rates: low and high, with two diverse tools: twist and brad type drill, while cutting speed was kept constant. Thrust forces during drilling were monitored. Then, delamination area around the hole was assessed by using digital images that were processed using a computational platform previously developed. Finally, drilled plates were mechanically tested for bearing and open-hole resistance. Results were compared and correlated with the measured delamination. Conclusions contribute to the understanding of natural fibres reinforced plastics as a substitute to glass fibres reinforced plastics, helping on cost reductions without compromising reliability, as well as the consequence of delamination on mechanical resistance of this type of composites.
- Drilling tool geometry evaluation for reinforced composite laminatesPublication . Durão, Luís M.; Gonçalves, Daniel J. S.; Tavares, João Manuel R. S.; Albuquerque, Victor Hugo C. de; Vieira, A. Aguiar; Marques, A. T.In this work, a comparative study on different drill point geometries and feed rate for composite laminates drilling is presented. For this goal, thrust force monitoring during drilling, hole wall roughness measurement and delamination extension assessment after drilling is accomplished. Delamination is evaluated using enhanced radiography combined with a dedicated computational platform that integrates algorithms of image processing and analysis. An experimental procedure was planned and consequences were evaluated. Results show that a cautious combination of the factors involved, like drill tip geometry or feed rate, can promote the reduction of delamination damage.
- Tool effects on hybrid laminates drillingPublication . Durão, Luís M.; Tavares, João Manuel R. S.; Albuquerque, Victor Hugo C. de; Marques, A. T.; Magalhães, A. G.; Vieira, A. AguiarFiber reinforced plastics are increasing their importance as one of the most interesting groups of material on account of their low weight, high strength, and stiffness. To obtain good quality holes, it is important to identify the type of material, ply stacking sequence, and fiber orientation. In this article, the drilling of quasi-isotropic hybrid carbon +glass/epoxy plates is analyzed. Two commercial drills and a special step drill are compared considering the thrust force and delamination extension. Results suggest that the proposed step drill can be a suitable option in laminate drilling.